Chicco 8058664036585 Instructions For Use Manual page 18

ies or the rechargeable lithium-ion
battery must always be carried out
only by an adult and with recharge-
able batteries having the same char-
acteristics as those mentioned in this
instructions manual.
- The Baby unit is equipped with a
light-sensitive sensor that automati-
cally activates the infrared LEDs thus
allowing viewing in low light condi-
tions.
- Since the infrared LEDs on the Baby
unit do not emit visible light, test by
checking the image transmitted from,
when the Baby unit is positioned in a
dimly lit room.
- The infrared LEDs on the Baby unit
are not harmful to health.
Configuration & Features
1 System features
1.1Baby unit
1. Power via 100-240V~, 50/60Hz
/6.5V , 550mA mains switching
adapter or via 4 1.5V AA /LR6 Alkaline
batteries (not included).
2. On/Off button
3. Night light On/Off button
4. Nightlight
5. Camera lens
6. Microphone
7. Infrared lighting system (8 LEDs) to
allow viewing of the baby in the dark
8. Light-sensitive sensor
9. Power and link indicator light:
(a) Steady green: linked with parent
unit
(b) Flashing green: absence of or loss
of link with parent unit
(c) OFF: Baby unit off
10. Alkaline battery compartment
closing panel
11. Baby unit power connector
12. Alkaline battery status indicator
light:
(a) Flashing red: Alkaline batteries al-
most flat
(b) OFF: Alkaline batteries charged or
operation via mains adapter (1)
1.2 Parent unit
1. Power via supplied rechargeable
3.7V, 1800mAh lithium-ion battery
or via 100-240V~, 50/60Hz /6.5V
, 550mA mains switching
adapter
2. On/Off button
3. Lit level indicator bar for sounds
emitted by the baby (3):
Illuminates progressively from the
centre outward, indicating 3 levels of
sound intensity coming from the Baby
unit microphone (6)
Allows parents to monitor sounds
emitted by the baby even when the
parent unit loudspeaker volume is
switched off.
: the central LED lights up
if sounds emitted by the baby are of a
relatively low intensity.
: 3 LEDs light up if sounds
emitted by the baby are of medium
intensity.
: 5 LEDs light up if sounds
emitted by the baby are of a relatively
high intensity.
Attention: After switching on the par-
ent unit always check the power sta-
tus of the Baby unit!
After switching on the unit, always
check that reception of the transmit-
ted signal is possible at the distance
and/or in the areas within where it has
been set. It is advisable to carry out a
test with the help of a family member
from the room where the Baby unit
has been placed, moving simultane-
ously with the parent unit in areas
18