Brother HL-660 Series User Manual page 60

English
USER'S GUIDE
6–2
For errors shown below, the printer indicates an operator call by blinking
the ALARM lamp and printing the error messages on paper.
Error Action
Memory Full
Press the FF/CONT switch to print the data
remaining in the printer.
If you are using the supplied Windows driver, try
again after changing the following settings. The
best combination of the settings below varies
depending on your document.
Expand the printer memory by adding a
commercially available SIMM.
Reduce the print resolution or reduce the complexity
of your document.
Print Overrun
Press the FF/CONT switch to print the data
remaining in the printer.
If you use the supplied Windows driver, try again
after changing the following settings. The best
combination of the settings below varies depending
on your document.
If this does not clear the error, reduce the
complexity of your document or reduce the print
resolution.
Expand the printer memory by installing SIMM and
set page protection ON by using the supplied
Windows driver or RPC program.
Centronics
Press the FF/CONT switch to resume printing.
Interface Line
Check that the connection between your computer
Error
and printer is secure and correct, and check the
interface cable.
Note
If the printer does not operate as you expect it to, it is recommended that
you perform a user reset or factory reset with the switches or unplug the
printer, wait a few seconds and then plug it in again. If you still have
problems, consult your dealer or our authorized service representative.
Graphics Mode
TrueType mode
User Printer TrueType™ Fonts
Page Protection
Graphics Mode
TrueType mode
User Printer TrueType™ Fonts
Page Protection