Table of Contents
Advertisement
English
USER'S GUIDE
FF/CONT(TEST) Switch
3–4
RESET Switch
Depress and hold the RESET switch until all four lamps arelit. The
printer is then reset and restored to the user default settings. While the
switch is being depressed, the printer ignores any data. If the switch is
released before all the lamps are turned on, the reset function does not
work. The RESET switch may be able to cancel an error status.
Caution
Remember that the RESET switch clears data from the printer memory
and puts the printer into sleep mode.
The upper switch on the control panel can work as the Form Feed (FF),
Continue (CONT) or Test print (TEST) switch.
FF/CONT Switch
If the DATA lamp is on, press the FF/CONT switch. The printer prints
any data remaining in the printer memory.
When you use the manual feed slot, the FF/CONT switch is used as the
Form Feed (FF) switch. When you see the MANUAL lamp blinking,
insert paper all the way into the manual feed slot and press the FF/CONT
switch. After pressing the FF/CONT switch the printer loads the paper
and begins printing. Remember that you need to press this switch to load
every sheet manually.
If an error occurs, the printer can recover from recoverable errors such as
cover open error automatically. If the error does not clear automatically,
press the FF/CONT switch to clear the error and continue the operation.
TEST Switch
Keep the TEST switch depressed until all lamps are turned on to execute
the test printing. If the printer is on-line and print data remains in the
printer memory, the printer cannot print a test sample page. If the printer
is off-line and data remains in the printer memory, the printer prints the
remaining data first and then prints a sample page.
Advertisement
Table of Contents
