National Instruments MXI Getting Started page 37

Appendix A Default Settings
VXI/VME-MXI-2
Hardware Settings
PCI-Based MXI-2 Interfaces for Windows 2000/NT/Me/98
Table A-6. PCI Tab Default Settings
Editor Field
Low-level register access API support
User window size
Expansion ROM
This section summarizes the hardware and software default settings for the
VXI-MXI-2, VXI-MXI-2/B, and VME-MXI-2.
Table A-7. VXI-MXI-2 Hardware Default Settings
Hardware Component
Logical address (U43)
VXIbus Slot 0/Non-Slot 0 (W2)
VXIbus local bus (S8, S9)
VXIbus CLK10 routing (W3)
External trigger termination (S2)
SMB CLK10 direction (S3)
SMB CLK10 termination (S4)
Polarity of external SMB CLK10 (S5)
MXIbus CLK10 signal (S7)
1
Automatic detection
Both OFF: single
VXI-MXI-2
From onboard oscillator
OFF: unterminated
OUT: drive CLK10 signal
Ignored; effective only when
S3 is set to IN
Inverted
Receive CLK10 from
MXIbus
A-4
Default Setting
Enabled
64 KB
Enabled
Default Setting
ni.com