After Using The Machine; Maintenance - Milwaukee HEAVY DUTY AS-30 MAC Original Instructions Manual

CAUTION!
The machine is equipped with a water level limit system which shuts
from the socket and empty the container. Never pick up liquids without
•
•
and check that the water level limit works properly.
• If foam appears, stop work immediately and empty the tank.
• Clean the water level limiting device regularly and check for signs of
damage.
Before emptying the container, unplug the machine. Disconnect the
hose from the inlet by pulling out the hose. Release the latches by
pulling them outwards so that the motor top is released. Lift up the
motor top from container. Always empty and clean the container and
water level limit system after picking-up liquids.
Empty by tilting the container backwards or sideways and pour the
Replace back the motor top to the container. Secure the motor top with
the latches.
Large movements can, by mistake, trigger the water level limiting
seconds to reset the device. Continue to operate the machine
afterwards.
CAUTION!
Materials picked up can present a hazard to the environment.
• Dispose of the dirt in accordance with legal regulations.
Before use, operators shall be provided with information, instruction
and training for the use of the machine and the substances for which it
is to be used, including the safe method of removal and disposal of the
material collected.
Remove the electrical plug from the socket before emptying after dry
pick-up. Remove the suction hose from the machine and close the inlet
cap, to avoid harmful dust spreading. Release the latch by pulling them
outwards so that the motor top is released. Lift up the motor top from
container.
Dustbag: Replace dust bag if necessary. Remove the old bag. The
located and secured on the locating rings of the rubber vacuum inlet.
clothing when removing the old bag. Carefully remove the dust bag
Dispose of the dirt in accordance with legal regulations.
After emptying: close motor top to the container and secure the motor
.
Before being taken out of the hazardous zone, the device must be
decontaminated using a dust extraction method, wiped clean, or
sealed. All parts of the device must be regarded as contaminated if
they are removed from the hazardous zone and suitable measures
must be taken to prevent dust from spreading.
OVERLOAD PROTECTION FOR SOCKET OUTLET
An external power tool can be connected to the socket outlet. The
socket has an overload device to protect the machine against power
overload. If the power consumption gets too high the overload device
overload device. The overload device needs around 1 minute to cool
down before it can be reset, pressing the button marked "13" on page
3.

AFTER USING THE MACHINE

After use
Remove the plug from the socket when machine is not in use. Wind up
the cord starting from the machine. The power cord can be wound up
around the motor top or at the container or placed in the included hook,
or fastening means. Some variants have special storage places for
accessories.
Transport
• Before transporting the machine, close all the latches.
• Do not tilt the machine if there are liquids in the dirt tank.
• Do not use a crane hook to lift the machine.
• Do not lift the machine by the trolley handle
Storage
CAUTION!
Store the appliance in a dry place, protected from rain and frost. The
machine shall be stored indoors only.
Accessory and tool storage
For convenient transport and storage of accessories or tools,
integrated rails are found on side of machine which allows fastening
back of machine for attachment of suction hose or mains cable. For
instruction see quick reference guide.
An optional adapter plate with attachment system can be installed on
top of machine for fastening of 2-point or 4-point storage cases.
Remove the electrical plug from the socket before installing the
adapter plate.
CAUTION!
Do not lift machine in adapter plate without having storage case safely
installed. Note the weight and balance of the appliance in case of
storage. Maximum weight of storage cases is 30 kg.

MAINTENANCE

Regular servicing and inspection
Regular servicing and inspection of your machine must be carried out
and regulations. In particular, electrical tests for earth continuity,
25