Craftsman CMCS4000 Manual page 9

Assembly (Fig. A, B–H)
1. Place the tool on a stable, level surface.
2. Unlock cutting cart by pulling out on the cutting cart
2
lock pin and slide the cutting cart back to reveal the
3
blade housing.
Fig. B
3. Install blade 16 onto the arbor
fully on the arbor and fitted with the rotational direction
matches the direction of the washer.
Fig. C
16
29
4. Install outer clamp washer
holding blade in place, fully tighten blade nut with
supplied wrench .
4
nOTE: Do not overtighten. Make sure the tile blade is
secure before use.
2
3
29 . Ensure the blade is
13
12
12 and blade nut 13 . While
Fig. D
16
5. Loosely install splash hood bracket
supplied splash hood bracket screws
Fig. E
14
6. Use supplied edge guide
bracket 14 and blade 16
tighten hood bracket screws.
Fig. F
16
7. Remove carriage bolt 17
hood 5 and install splash hood onto the splash hood
bracket. Insert carriage bolt through both the splash
hood and bracket. Install and loosely tighten the nut.
Adjust the height for your specific application. Fully
tighten the nut.
English
12
13
using the two
14
15 .
15
to align splash hood
10
. Once bracket is aligned, fully
14
10
and nut 18 from splash
7