Craftsman CMCS4000 Manual page 11

Fig. K
On/Off Switch (Fig. L, M)
• To turn the wet tile saw on, lift up the on/off switch
• The wet tile saw locks on automatically.
• To turn the tool off, push the on/off switch down.
NOTE: A removable safety lock
deter unauthorized use.
Fig. L
1
Fig. M
26
1 .
26 can be removed to
Filling and Draining the Water Reservoir
(Fig. N)
1. Plug the water reservoir drain hole
drain plug 22 . Secure the drain plug into position
by tightening the attached wing nut
Figure N.
2. Slowly fill the water reservoir to the MIN fill line
prevent accidental overfilling. Do not fill above the MAX
fill line 25 .
3. To drain the reservoir, place a 5 gallon (19 liter) bucket
under the drain plug.
4. Remove the drain plug by loosening the attached wing
nut and allow the water to empty into the bucket.
Fig. N
25
24
22
Making a Cut (Fig. A)
Verify the proper alignment of the cutting cart and blade
before turning the saw on.
Always keep hands away from the blade.
1. Lift the On/Off switch
1
the stream of water completely covers the blade.
nOTE: Cutting tile without water will damage the blade.
2. Ease the cutting cart toward the blade then slowly feed
the tile into the blade. Continue pushing until the blade
cuts completely through the tile.
3. Turn the saw off by pushing the On/Off switch
4. After the blade stops, remove the tile and remnant from
the cutting cart.
Locking the Cutting Cart (Fig. O)
There is one locking position for the cart.
Move the cart to the lock position and lock the cart by
pushing the pin 3 into a hole in the rail.
English
21 with the
as shown in
23
24 , to
23
21
to turn the saw on. Wait until
down.
1
9