Brother DCP-8060 User Manual page 55

Error Message Cause
The temperature of the fuser unit
Fuser Error
does not rise at a specified
temperature within a specified time.
The fuser unit is too hot.
No Paper
The machine is out of paper or
paper is not properly loaded in the
paper tray.
The paper tray is not completely
No Tray
closed.
The machine's memory is full.
Out of Memory
The paper is jammed in the back of
Paper Jam
the machine.
Back
The paper is jammed inside the
Paper Jam
machine.
Inside
The paper is jammed in the MP tray
Paper Jam
of the machine.
MPTray
The paper is jammed in the paper
Paper Jam
tray of the machine.
Tray1
Paper Jam
Tray2
It is time to replace the fuser unit.
Replace Fuser
It is time to replace the laser unit.
Replace Laser
It is time to replace the paper
Replace PF
feeding kit for Tray 1.
Kit1
It is time to replace the paper
Replace PF
feeding kit for Tray 2.
Kit2
50
Action
Turn the power switch off, wait a few seconds,
and then turn it on again. Leave the machine for
15 minutes with the power on.
Do one of the following:
Refill the paper in the paper tray or MP tray.
Remove the paper and load it again.
Close the paper tray properly.
Copy operation in progress
Do one of the following:
Press Start to copy the scanned pages.
Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
Printing operation in process
Do one of the following:
Reduce print resolution. (See Advanced tab
in the Software User's Guide on the
CD-ROM.)
Turn on the Page Protection function. (See
Device Options in the Software User's Guide
on the CD-ROM.)
Clear the data from the memory by pressing
Job Cancel.
(See Paper jams on page 53.)
(See Paper jams on page 53.)
(See Paper jams on page 53.)
(See Paper jams on page 53.)
Call Brother Customer Service to replace the
fuser unit.
Call Brother Customer Service to replace the
laser unit.
Call Brother Customer Service to replace the PF
Kit 1.
Call Brother Customer Service to replace the PF
Kit 2.