Wii Ac Adapter - Nintendo Wii Operation Manual

~¥'
33 0
3
3
E '6
System Setup
I Using the Sensor Bar Stand
Communication between the Wii Remote and the Sensor Bar may be improved in some situations by mounting the Sensor Bar on the Sensor Bar stand; for example, ifthe1V is
sitting on the floor.
1. Remove the protective film from the foam pads
on the bottom ofthe Sensor Bar stand.
2. For additional stability, you can add adhesive badred foam tape from the supplied sheetihese can be applied
to both the top and bottom of the stand.
5. Mount the Sensor Bar stand to:
0 the front edge of the surface theiV is sitting on, or
0 to the top of the ill.
be not place the Sensor Bar stand below the
surface that then! is sitting on; for example, on
shelves below the 'IV.
3. it you are using the extra foam tape, 4. Attach the Sensor Bar stand to the Sensor Bar, aligning the pegs
remove the protective him from the on the stand with the holes in the bottom of the Sensor Bar.
piece on the top ofthe Sensor Bar stand.
Besureto:
0 Altgnthecenterofthesensorllarwlththeoenteroftheltl.
0 Alignthetrontotthesensornarwiththetrontedgeofthemorwiththefrontedgeof
thesurtaoethattheiiiissitting on.
16
ihe Sensor Barstand can also be used on top ofihe1Vif partoftheiVbioclts, or
prevents proper installation of, the Sensor Bar.
YES
Make sure the Sensor Bar is horizontal
and it is not blocked bythelli.
I Sensor Bar cable position
if desired, the Sensor Bar cable can be fed through a channel on the bottom of the
Sensor Bar to orientthe able to the left or right.
Wii AC Adapter
1. |nserttheDC plug ontheWiiACMaptercord intothebcinputconnectoronthe
back of the console.
2. Insert the AC plug into a 120VAC wall outlet. llake sure the power is off (the
Power LED is red) when unplugging the Ac Adapter.
uunou: To prevent electric shoclr, match the wide blade of the plug to the
wide slot and insert fully into outlet.
S y s t e m S e t u p