Advertisement
6 To clean the tweezer element, use the
cleaning brush dipped into alcohol.
Clean the tweezers with the brush from
the rear side of the epilator head while
turning the barrel manually. After
cleaning, place your preferred
attachment
1a
epilation head.
B How to use the shaver head
8
OptiTrim attachment
8a
Shaving foil frame with long hair
8b
trimmer
Release bars
8c
Cutter block
8d
Shaver head base
8e
1 Remove the OptiTrim
Put on the shaver head
it in (the long hair trimmer should be in
front).
or
back on the
1b
a
b
c
d
e
attachment.
8a
by clicking
8
2 When using the shaver head, always
slide the switch up to the «optimal»
setting.
3 For best results, guide the shaving
system in a way that about half of the
shaving foil and the long hair trimmer
are in contact with your skin. Always
guide the appliance in the direction of
the trimmer. The trimmer first raises all
long hairs and cuts them off. Then the
flexible foil follows to smooth away
any stubble.
Important: Always stretch your skin
when shaving.
Pre-cutting hair for epilation
4 If you choose to pre-cut your hair to
the ideal length for epilation, place the
OptiTrim attachment onto the shaver
head.
5 Hold the appliance with the OptiTrim
attachment ensuring that the surface
of the comb is lying flat on the skin.
Guide the appliance with the comb
tips against the hair growth (B 5).
N.B. As hair does not always grow in
the same direction it may be difficult to
cut. In which case, guide the appliance
slightly diagonally or in different
directions.
Cleaning the shaver head
6 After shaving, unplug the appliance
and, if necessary, remove the OptiTrim
attachment.
7 Clean the OptiTrim attachment with
the brush.
8 In order to clean the shaver head,
remove the shaving foil frame
To do so, press the release bars
the front and back and pull it off.
9 Carefully tap the shaving foil frame on
a flat surface.
10 Brush out the cutter block
the area below the cutter block.
.
8b
on
8c
as well as
8d
9
Advertisement
