Siemens SIMATIC NET S7-300 Manual page 242

7 Programming FCs (Functions) and FBs for S7 Ethernet CPs
FC11 PNIO_SEND - continued
Condition Codes
The following table shows the condition codes formed by the DONE, ERROR and
STATUS parameters that must be evaluated by the user program.
Note
For entries coded with 8Fxx
Standard and System Functions reference manual. The chapter describing error
evaluation with the RET_VAL output parameter contains detailed information.
To find out which SFCs are used and are relevant for error evaluation, display the
properties dialog of the FC described here in the "Calls" tab.
Table 7-11 Condition Codes PNIO_SEND
DONE ERROR
0 0
1 0
0 1
0 1
0 1
0 1
0 1
0 1
0 1
0 1
0 1
0 1
A -242
in STATUS, refer to the information in the STEP 7
H
STATUS
S
8180 Data transfer active;
H
or
S
The CP is in STOP mode
0000 New data transferred without error.
H
S
8183 PROFINET IO configuration missing;
H
or
S
wrong CPLADDR;
or
S
The CP is in STOP mode
Extra in device mode:
S
The connection between PROFINET IO controller and
PROFINET IO device is down,
or
S
PROFINET IO controller not reachable
or
S
Total lengths (configuration and LEN parameter) are not
consistent.
8184 System error or illegal parameter type<F 9>.
H
8185 LEN parameter longer than SEND source area.
H
8F22 Area length error reading a parameter (e.g. DB too short).
H
8F23 Area length error writing a parameter (e.g. DB too short).
H
8F24 Area error reading a parameter.
H
8F25 Area error writing a parameter.
H
8F28 Alignment error reading a parameter.
H
8F29 Alignment error writing a parameter.
H
8F30 Parameter is in the write-protected 1st act. data block.
H
Meaning
S7-CPs for Industrial Ethernet Configuring and Commissioning
Release 01/2007
C79000-G8976-C182-07