Programming The Universal Remote Control - Boston Acoustics DT6000 User Manual

BDT6000R (REV5).ƒ 11/22/99
P rogramming the Universal Remote Contro l
This universal remote is pre - p rogrammed for hundreds of diff e rent devices.
Install the 4 "AAA" batteries in the remote. Orient the batteries (+ or -) as shown in the battery
c o m p a rtment.
For your TV, VCR, cable box, DSS, or DVD player, look up the three-digit code for your part i c u l a r
model in the included booklet.
1 8
5:45 PM Page 18
• •
2
4
•
1
•
3
•
P ress the button for the unit you wish to pro-
1 .
1
g r a m —T V, VCR or cable box. The LED on the
remote will blink.
• The V C R button can also be used to pro-
gram DVD player codes, in place of the VCR.
• The c a b l e button can also be used to pro-
gram DSS codes, in place of the cable box.
•
3. Hold the s e t u p button on the remote contro l
2
for about three seconds, until the LED on
the remote blinks twice.
•
3. Enter the three-digit code for your part i c u l a r
3
device. The LED on the remote will blink once
after the first two numbers are entered, and
twice after the last number is entered to signi-
fy it has accepted the programming. Example:
1 (blink), 2 (blink), 3 (blink-blink). A single long
blink indicates an invalid key sequence.
•
4 . Test the remote control on your device by
4
p ressing p o w e r on or off .
If the remote does not appear to be working,
check that the right code was pro g r a m m e d .
Many manufacturers have multiple codes for
d i ff e rent devices; if the first code doesn't work,
t ry a diff e rent code. Make sure the LED on the
remote blinks every time a button is pressed.
If not, be certain the batteries are corre c t l y
installed or replace the batteries in the re m o t e
c o n t ro l .