Loading Film - GBC Arctic Titan 1040WFC Installation And Operating Manual

LOADING FILM

Fig. 6-3. Poly-In and Poly-Out Films
© 2006 General Binding Corporation
The Artic Titan 1040 WF c and Artic Titan 1064 WF c
laminators runs poly-in and poly-out pressure sensitive
adhesive (PSA) films. Poly-in means the adhesive side of
the film is on the inside of the film roll. Poly-out means the
adhesive is on the outside of the film roll.
The machine can perform three functions:
•
Decaling (laminating and applying an adhesive to the
back of the item).
•
Mounting, using one film.
•
Mounting, using no film.
IMPORTANT: The top and bottom rolls of laminating
film must be the same width.
Always change the top and bottom supply rolls at the same
time.
The film will wrap around the rollers if:
•
One or both rolls of film are allowed to run
completely off its core.
•
Only one roll is used.
•
Different widths of rolls are loaded together.
•
Either roll is loaded with the adhesive side against a
roller.
There are two methods of loading film.
•
Using a threading card.
•
Tacking new film to existing film.
Prior to loading film, the print clamp and feed table need to
be removed.
15 Page