AT&T AUDIX Voice Power Installation And Maintenance Manual page 78

Installing on System 75
and System 25 Without IS-II
AUDIX Voice Power may be installed when you receive your system.
You will need to install AUDIX Voice Power only when:
•
your system is not preassembled by AT&T
•
AUDIX Voice Power is added to the system after the initial purchase
•
you are upgrading from a previous release of AUDIX Voice Power
•
there has been an unrecoverable system failure
To install AUDIX Voice Power, you need the following:
•
UNIX Operating System V/386 Release 3.2.2 (or later) Foundation Set
The set includes:
– Base System Package
– FMLI Package
– FACE Package
– FACE HELP Package
– Editing Package (optional)
•
AUDIX Voice Power System Modification Software
•
Integrated Voice Power System Software, Release 1.1
•
AUDIX Voice Power Application Software, Release 2.0
•
AUDIX Voice Power Switch Integration Software R2.O for
System 75 PBX or DEFINITY® G1 PBX
or
AUDIX Voice Power Switch Integration Software R2.O for
System 25 PBX
•
Cartridge Tape Utility Package (if you have a tape drive installed)
•
Remote Terminal Package (if you have a remote access terminal)
3-2 Software Installation