Pnp/Pci Configurations - ECS RC410-M2 Manual

34
Parallel Port Mode (ECP)
This item allows users to manually set the Paralle Port Mode.
ECP Mode DMA Channel (DMA3)
This item allows users to manually set the DMA Channel for ECP Mode.
Parallel Port IRQ (IRQ7)
This item allows users to manually set the Paralle Port IRQ value.
Press <Esc> to return to the Main BIOS Setting page.
PnP/PCI Configuration
These options configure how PnP (Plug and Ply) and PCI expansion cards operate in your
system.
Allocate IRQ to PCI VGA
PCI IDE BusMaster
PCI/VGA Palette Snoop
F7:Previous Values
Allocate IRQ to PCI VGA (Enabled)
This item allows users to enable or disable the function of allocating IRQ to PCI VGA.
PCI IDE BusMaster (Enabled)
This item allows users to enable or disable the PCI IDE BusMaster function. Users are
recommended to keep this item at its default value.
PCI/VGA Palette Snoop (Disabled)
This option is only very rarely needed. It should be left at "Disabled" unless a video
device specifically requires the setting enabled upon installation.
Press <Esc> to return to the Main BIOS Setting page.
CMOS Setup Utility - Copyright (C) 1985-2004, American Megatrends, Inc.
PnP/PCI Configuration
[Enabled]
[Enabled]
[Disabled]
+/-/: Value
: Move
Enter : Select
F8: Fail-Safe Defaults
Using BIOS
Help Item
YES: Assign IRQ to PCI
VGA card if card requests
IRQ.
NO: Does not assign IRQ
to PCI VGA card even if card
requests an IRQ.
F10: Save ESC: Exit
F1: General help
F9: Optimized Defaults