Removing The Monitor - Boss Audio Systems BV6VIS User Manual

Removing the monitor

Should you need to remove the monitor from the shroud, insert the removal key
as shown in the diagram below.
Insert the two prongs of the key into the gap between the monitor and the shroud
(as shown in the diagram) to depress the two snap catches on the side of the
monitor which secure it. Then use the key to gently lift the right side of the monitor
out of the shroud and remove it.
Be sure to push the monitor all the way back in until you feel a click when you are
reassembling the monitor system.
Insert the removal key into the gap
on the right side of the monitor to
depress the tabs to release it.
Changing the battery in the remote control
The remote battery is held in a small "drawer" on one edge of the remote. To open
this drawer, press and hold the small button on the edge of this drawer (as shown
below) and slide the drawer out.
Insert a new battery and push the drawer back fully into the remote.
Release button
BV6VIS User's Manual - page 10
Battery