Boss Audio Systems BV650M User Manual
Boss Audio Systems BV650M User Manual

Boss Audio Systems BV650M User Manual

Boss audio bv650m: user guide

Advertisement

Quick Links

Advertisement

Table of Contents
loading

Summary of Contents for Boss Audio Systems BV650M

  • Page 2: Important Safety Instruction

    CONTENTS Important Safety Instruction Installation DIN Front-Mount (Method A) Installing the unit Removing the unit DIN Rear-Mount (Method B) Wiring Connection Operation Location and function of keys Switching onloff the unit Openlclose the monitor and angle adjustment Remote sensor Liquid crystal display inch TFT display Reset function Operating when the monitor not...
  • Page 3: Take Out Screw Before Installation

    INSTALLATION Notes: TAKE OUT SCREW BEFORE INSTALLATION Choose the mounting location where Before install the unit, please remove the the unit will not interfere with the normal two screws on the back of the unit. driving function of the driver. Before finally installing the unit, connect the wiring temporarily and make sure Take out screw before installation...
  • Page 4: Wiring Connection

    INSTALLATION DIN REAR-MOUNT (Method B) Removing the unit 1. Make sure the ignition is turned off, and then disconnect the cable from the vehicle battery's negative (-) terminal. 2. Remove the metal strap attached the back of the unit (if attached). 3.
  • Page 5: Operation

    OPERATION LOCATION AND FUNCTION OF KEYS Fig. A Fig. OPERATION LOCATION AND FUNCTION OF KEYS ( ? , / I (OpenIClose button) MUTE TFT Monitor VOLUME+ VOLUME- Reset button .. . 11. BND 12. MODE 13. TUNE 14. TUNE- 17. AUDIO INPUT 1 18.
  • Page 6: Adjusting The Loud

    OPERATION Adjusting the loud Radio Operation VOLUME - In loud mode, use Switching to radio mode buttons (7&8) or VOL buttons Press MODE button (1 2) on the front (47) to switch between loud on and off. panel or MODE button (42) on the When LOUD on, "LOUD"...
  • Page 7: Operating When The Monitor Stretching Out

    OPERATION OPERATING WHEN THE MONITOR ST/MO button (53) on remote control to STRETCHING OUT select "MONO" or "STEREO". When the monitor stretches out, the front panel of the unit is in state 13 (see Fig.B), you can operate the unit by using the current menu displayed on the 6.5 inch VOLUME color TFT display (5).
  • Page 8: Control & Function Keys

    TV OPERATION CONTROL & FUNCTION KEYS This type can't be used separately and it must be used with other special system with the 13-pin din plug. The unit is connected to another system through the 13-pin din socket (2). And the unit also can receive l V signal through the antenna input jack (1). 1.
  • Page 9: Specification

    N OPERATION adjust the selected item. The corresponding value will show on the display. Volume adjustment Press VOLUME4 buttons (23822) or VOL buttons (47) to adjust volume level. Screen display Press DSP button (20) on the front panel or DlSP button (44) on remote control to display the current status such as TVch/AVl/AV2.

Table of Contents