Keyless Locking And Starting System "Keyless Access - Volkswagen ID.4 Owner's Manual

OR:
— Remove the spare key → page 73.
— If necessary, remove the cover of the driv-
er door handle→ page 80.
— Press the button on the vehicle key.
— Unlock the vehicle using the spare key.
— Open the driver door. If the vehicle has an
anti-theft alarm, this will be triggered im-
mediately → page 83.
— Switch on the ignition. Please note: to
switch on the ignition, place the vehicle
key in the drink holder or the stowage
compartment in the centre console
→ page 139.
The synchronisation process is complete.
Troubleshooting
Vehicle cannot be locked or unlocked
The remote control is subject to interference
caused by obstacles, adverse weather condi-
tions or other transmitters operating in the
same frequency range in the vicinity of the
vehicle, e.g. mobile devices, or due to a weak
or flat button cell.
OR: the central locking system has switched
itself off temporarily to protect itself against
overloading.
— Close the driver door.
— OR: synchronise the vehicle key
→ page 74.
— OR: change the button cell in the vehicle
key → page 74.
Indicator lamp does not flash
If the indicator lamp in the vehicle key does
not flash when pressing the button, the but-
ton cell in the vehicle key has to be replaced
→ page 74.
Additional or replacement vehicle keys
can be obtained from a Volkswagen
dealership.
Keyless locking and start-
ing system "Keyless Ac-
cess"
Introduction to the topic
The Keyless Access function allows the vehi-
cle to be unlocked and locked without active-
ly using the vehicle key. For this purpose,
a valid vehicle key must be within close range
of the vehicle.
Unlocking or locking the vehi-
cle with Keyless Access
Fig. 57
Fig. 58
Configuring Keyless Access
The behaviour of the keyless access locking
and starting system Keyless Access can be

Keyless locking and starting system "Keyless Access"

In the door handle: sensors.
Keyless Access: operating ranges.
75