Remote Commands - Brother MFC-4800 User Manual

Remote Commands

Follow the commands below to access features remotely. When you call the
FAX/MFC and enter your Remote Retrieval Access Code (1 5 9
will signal you with two short beeps to enter a remote command.
Remote Commands
95 Changing Fax Forwarding
/Paging setting
1 OFF
2 Fax Forwarding
3 Paging
4 FAX FWD No.
6 Fax Storage ON
7 Fax Storage OFF
96 Retrieve a fax
2 Retrieve all faxes
3 Erase faxes from the memory
97 Check the Receiving Status
1 FAX
98 Change the Receive Mode
1 TAD: ANSWER MACH.
2 FAX/TEL
3.FAX ONLY
90 Exit
Operation Details
If you hear one long beep, the change is accepted. If you hear three
short beeps, you cannot change it because the conditions have not
been met (Example: registering paging number). You can register
your fax forwarding number by using 4. FAX FWD NO. (see page
9-5). Once you have registered the number, the FAX/MFC will
change automatically to FAXFWD:ON mode.
You can turn FAX STORAGE to ON or OFF.
Enter the number of a remote fax machine to receive stored fax
messages. (See page 9-5.)
If you hear one long beep, you can erase fax message(s) from the
memory.
You can check whether your FAX/MFC has received any faxes.
If yes, you will hear one long beep. If no, you will hear three short
beeps.
If you hear one long beep, you can change the Receive Mode.
If you hear three short beeps, you cannot change it.
After a long beep, you can exit Remote Retrieval.
R E M O T E F A X O P T I O N S
), the system
9 - 4