Making The Connections - Bose SL-2 Owner's Manual

Svenska Nederlands
Y SL2
OUR WIRELESS SURROUND LINK

Making the connections

Use the small power pack with the SL2 transmitter (Figure 3). The large power pack is for use
with the SL2 receiver.
Figure 3
Different power
supplies
Before you plug either of the supplied power packs into the wall, make all the other
connections.
Connecting the SL2 transmitter
Use the supplied transmitter cable to connect the SL2 transmitter to your Acoustimass
module, as follows (Figure 4):
1. Insert the single connector at one end of the cable into the input jack labeled
2. Connect the other end of the transmitter cable to jacks on the Acoustimass module.
3. Connect the cable end of the transmitter power pack to the small jack labeled DC Power
4. Plug the transmitter power pack into a nearby AC mains outlet.
Figure 4
Transmitter
connections
When the power supply is plugged in, a Status LED on the back of the transmitter blinks
green until it links to the receiver. It then lights a solid orange until there is an audio signal to
transmit.
6
Italiano
SL2 transmitter
Input jack
Transmitter
power pack
Acoustimass Module on the back of the SL2 transmitter.
• Insert the purple connector marked RR into the jack labeled Right Rear or Surround R.
• Insert the green connector marked LR into the jack labeled Left Rear or Surround L.
on the back of the SL2 transmitter.
Status LED
SL2 transmitter
Transmitter
cable
Français Español
AC power jack
Acoustimass module
Surround
speaker jacks
Deutsch Dansk
SL2 receiver
Output jacks
Receiver
power pack
AC power jack
English
®
Transmitter
power
pack
(120V
shown)