SPE C IF I CAT I ON S
Electrical Requirements
Installation must comply with all applicable electrical codes.
Locate the electrical supply as shown in the illustration
below. A separate circuit servicing only this appliance is
required.
EL EC T R IC A L R EQ UI R EM ENT S
Electrical Supply
Service
30"
36"
(762) TO
(914) BOTTOM EDGE TO COUNTERTOP
Electrical location
RATING PLATE
Rating plate location
8 | Wolf Customer Care 800.222.7820
grounded, 120 VAC, 60 Hz
15 amp dedicated circuit
6"
E
(152)
5"
(127)
Hood Preparation
Remove the filters, spacers, and grease cup(s) prior to
installation.
To remove the filters, press upward, then rotate the bottom
downward. To remove the spacers, slide the spacer toward
the center of the hood slightly. Press upward and rotate the
bottom downward. To remove the grease cup(s), lift verti-
cally to remove from the rear flange. Refer to the illustrations
below.
Filters
FLANGE
GREASE
CUP
Grease cup
SPACER
Spacer