Using The Ir Emitter - Bose Lifestyle V30 Owner's Manual

English

Using the IR emitter

®
Normally, the Lifestyle remote can control all of your
source devices. However, in rare cases, some of your
source devices may not operate correctly under control of
®
the Lifestyle remote–for example, if your source devices
are stored in a cabinet with doors. The remote will operate
®
the Lifestyle system, but may not properly operate your
other source devices depending on their placement. To
overcome this problem, you can use one or both of the
supplied IR emitters.
Fi gu re 14 IR emitters
IR emitter extender
To use the IR emitter
If only one of your source devices is not responding:
1. Plug the IR emitter cord connector into the
®
Lifestyle media center IR emitter connector.
2. Temporarily position the emitter so that the flat side
is against the front panel of the source device.
IR emitter
DO NOT attach the supplied adhesive pad until
Not e:
you have tested emitter operation as explained below.
®
3. Using the Lifestyle remote, press the On/Off
button for that device.
Slowly move the emitter around while pressing the
remote On/Off button until the device responds.
4. Using the adhesive pad, attach the emitter to the
device.
If two or more devices are not responding:
1. Plug the IR emitter extender cord connector into
®
the Lifestyle media center.
Optionally, plug the IR emitter cord connector into
the IR emitter extender.
2. Place one or both IR emitters in a location near the
devices, such as on the shelf supporting the devices.
®
3. Using the Lifestyle remote, press the On/Off
button for each device.
Slowly move the emitter(s) around while pressing
the remote On/Off button for each of the devices
until all devices respond.
4. Using the adhesive pad(s), attach the emitter(s).
I
NSTALLATION
19