Troubleshooting (Initial Setup By Wps) - Panasonic HomeHawk SHELF Information And Troubleshooting Manual

T
roubleshooting (Initial setup by WPS)
What is WPS?
WPS is a function of wireless routers that is used to easily connect wireless devices to wireless routers�
A WPS button on a wireless router indicates that it has the WPS function� (Depending on the type of wireless
router‚ the WPS function may be disabled on the wireless router even if there is a WPS button�)
If you have trouble during the initial setup‚ check the following causes/solutions fi rst‚ and then turn off the
camera and restart it�
Problem
When initial setup The camera's
is performed LED indicator is
using WPS‚ the blinking in red�
following screen
is displayed and
the setup cannot
be completed�
HNC815C_ITG_(en_en)_0424_ver.040.pdf
Cause
The WPS function on
your wireless router
may be disabled�
The camera and
wireless router are
too far away�
The wireless router is
not in WPS mode�
15
Solution
Some Internet Service Provider wireless routers
may have WPS disabled�
• Try initial setup without using a WPS button on
your wireless router (Basic Setup)�
• Unplug the camera and then plug it in again‚
and then try again from the beginning�
• Move the camera and wireless router closer
together�
• Unplug the camera and then plug it in again‚
and then try again from the beginning�
• Press the WPS button on the wireless router
for long enough until the LED indicator on the
router starts blinking�
• Unplug the camera and then plug it in again‚
and then try again from the beginning�
15
2019/04/24 18:22:46