Brother MFC-8380DN User Manual page 145

Error Message
Out of Memory
Output Tray Full
Print Unable XX
(XX = Enter Code)
Protected Device
Rename the File
Replace Drum
Replace Fuser
Replace Laser
Cause
The machine's memory is full.
The ADF output tray has reached
its maximum capacity.
The machine has a mechanical
problem.
The protect switch of the USB
Flash memory drive is on.
There is already a file on the USB
Flash memory drive with the
same name as the file you are
trying to save.
The drum unit is at the end of its
life.
The drum unit counter was not
reset when a new drum was
installed.
It is time to replace the fuser unit. Call your Brother dealer to replace the fuser
It is time to replace the laser unit. Call your Brother dealer to replace the laser
Troubleshooting and routine maintenance
Action
Fax sending or copy operation in
progress
Do one of the following:
Press Start to send or copy the scanned
pages.
Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
Clear the data from the memory. (See
Out of memory message on page 44 or
page 88.)
Print operation in process
Do one of the following:
Reduce print resolution. (See Advanced
tab in the Software User's Guide on the
CD-ROM.)
Clear the faxes from the memory. (See
Out of memory message on page 88.)
Remove the scanned pages from the ADF
output tray. If you want to scan the remaining
pages of your documents, dial the fax
number (if you are sending a fax) and press
Start.
Disconnect the machine from the power for
several minutes, then reconnect it. (The
machine can be turned off for up to 60 hours
without losing faxes stored in the memory.
See Transferring your faxes or Fax Journal
report on page 137.)
Turn off the protect switch of the USB Flash
memory drive.
Change the file name of the file on the USB
Flash memory drive or the file you are trying
to save.
Replace the drum unit with a new one.
(See Replacing the drum unit on page 157.)
1 Open the front cover, and then press
Clear/Back.
2 Press 1 to reset.
unit.
unit.
C
135