Table of Contents
Advertisement
1.5.5
Rear Enclosure
1. Remove two screws from the rear enclosure.
2. Separate the rear enclosure (spare part no. 296476-001) from the monitor panel using the
Compaq Case Utility tool (Compaq tool kit #100767-001) to loosen the eight snaps (four on top
and two on the sides of the enclosure).
Figure 1-10. Removing the rear enclosure
To replace the rear enclosure, reverse this procedure.
If you are replacing the antireflective screen only, skip the next few sections and turn to section
1.5.9, Front Bezel Assembly.
Compaq TFT500 Flat Panel Monitor
1-11
Advertisement
Table of Contents
