Configuring Dialing - Lucent Technologies SLC ConnectReach User & Service Manual

®
Configuring the SLC ConnectReach
Using the Configuration Commands

Configuring Dialing

Introduction
™
System
The SLC ConnectReach system's dialing table provides the following LCR
options: translating seven- to ten-digit numbers, routing calls to either digital or
analog trunks, and translating special numbers such as 411, 611, and 911 to
seven- or ten-digit numbers.
The following figure shows that the SLC ConnectReach system intelligently routes
calls to the local CO or to long distance. By configuring the dialing table, long
distance calls go out by means of T1 (digital trunks) and local calls go out by
means of lines (analog trunks). Incoming calls from either digital or analog trunks
are routed to groups or stations.
363-208-050
(Continued on next page)
Issue 4 June 2002 4-89