Installation; Transportation And Handling; Positioning; Wiring And Electrical Hook-Up - U-Line UCFZ527-SS31A User Manual

2. INSTALLATION

2.1 TRANSPORTATION AND HANDLING

The equipment must be transported and handled exclusively in upright position, in
observance of the instructions printed on the packing.
This precaution is necessary to avoid contamination of the refrigerant circuit with compressor lube
oil with resulting valve and heat exchanger coil failure and problems starting the electric motor or
the risk of a gas leak. The manufacturer is not responsible for any problems due to transport
executed in conditions other than those specified herewith.
The equipment is secured to a wooden pallet base, wrapped in a plastic film and packaged into a
three waves carton box..
The equipment must be handled using a fork lift truck or a pallet truck with suitable forks (fork
length at least equal to 2/3 length of unit).

2.2 POSITIONING

Incorrect positioning can cause damage to the equipment and generate hazardous conditions for
personnel. The installer must therefore observe the following general regulations:
Make sure you maintain a minimum of 11,8" (30cm). clearance from the walls and 31,5" (80

cm) from the ceiling. The room must be well ventilated.
Keep well away from sources of heat. Avoid direct sunlight

Remove packing material.

Remove accessories from inside the unit.

Cartoon box or Wood base removal: using a hammer, tilt the cabinet to one side and loosen

the two thread-forming screws, drag the cabinet from the back side holding the base still until
the four castors have gone out from the containing holes, slightly tilt the cabinet backward and
take the base away pulling it from the front side.
Use gloves when handling the 3 Waves cartoon box or the wooden base to protect the hands
from splinters.
 Position the equipment with the help of a level. Remove the protective PVC film from the
external surfaces of the unit.
Position the shelf runners in the holes in the uprights. Insert the shelves in the runners.

Note: the shelves included are n.04 of GN2/1 per each door.
The maximum load of each is 48 kg. (30kg for the 12 cu.ft)
2.3

WIRING AND ELECTRICAL HOOK-UP

Receptacle installation and electrical wiring operations must be performed by a qualified
electrician. For safety reasons adhere to the following indications:
Check that the electrical plant is suitably sized for the absorbed power of the unit.

If the electrical socket and the plug on the equipment power cord are incompatible,

call technical service or your local distributor.
The power cord set included with the appliance meets the requirements for use in the

country of purchase. Use the power cord that shipped with the appliance (
If this appliance is to be used in another country, purchase an AC power cord set that
is approved for use in that country
Use and Operational Manual
13
OPERATION
).
Nema 5-15
13