Advertisement
Removing the power amp and supply
PCB and the power trans PCB
(See Fig.2, 3, 32, 34 to 37)
Prior to performing the following procedures,
remo
ve the top cover and both sides board.
Also remove heat sink cover.(Fig. 4)
1.
Remove the two screws "A" connecting the heat
sink cover to the rear panel.(Fig. 2.3)
2.
Pull out the heat sink co
3. Remove teh three (MX-K10)/ four(MX-K30)screws
"AA" form the (MX-K10) chassis /MX-K30 back panel
between the heat sink.
3.
Remove the two screws "X" that retain the
speaker terminals and AUX terminal.
4.
Remove the screw "YY" that retains the rear panel,
and then remove the rear panel.
5.
Disconnect the parallel wires from the connectors
FW951 on the power trans PCB.
6.
Remove the screw "Z" that retain the power amp
and supply PCB and then remove the assembly.
7.
Remove the clamp of AC power cord from the
chassis.
8.
Remove the four screws "AB" that retain the
power trans PCB and then remove the assembly.
FUSE 952
FUSE 951
1.6A 250V
1.6A 250V
FW951
For MX-K10
Fig.35 (A)
Power amp and
supply PCB
Chassis
Z
Fig.36
All manuals and user guides at all-guides.com
ver toward you.
FUSE 952
1.6A 250V
FW951
For MX-K30
Rear panel
AB
For MX-K10
X
For MX-K10
For MX-K10
FUSE 951
3.15A 250V
x
Y
For MX-K30
Fig.35 (B)
Clamp
Fig.37 (A)
YY
Fig.34 (A)
Fig.34 (B)
Fig.34 (B)
AB
For MX-K30
Fig.37 (B)
Clamp
AA
Clamp
1-17
Advertisement
