Advertisement
Removing the cassette deck heads
Prior to performing the following procedures,
remove the top cover and both sides board.
Also remove the CD changer unit.
Also remove the front panel assembly.
1.
Remove the five screws "O" that retain the cassette
deck mechanism.
2.
Remove the cassette deck mechanism and place it
so that the front side faces up.
3.
Remove the solder from the bottom side of the
head terminal and disconnect the wire.
4.
Remove the screw "U" that retains the head.
5.
Remove the screw "V" that retains the head.
6.
Hold the head and slide it in the direction of the
arrow to remove it.
Removing the 3-pin regulator Q904, Q907
Prior to performing the following procedures,
remove the top cover and both sides board.
1.
Remove the two screws "A" that connect the heat
sink cover to the rear panel.
2.
Pull the heat sink outward.
3.
Remove the screw "W" that retains the heat sink
the 3-pin terminal regulator. Q904, Q907
4.
Remove the solder fixing the 3-pin regulator.
1-16
All manuals and user guides at all-guides.com
(See Fig.22 and 31)
(See Fig. 32 and 33)
Cassette deck mechanism
(Front side)
PB Head
V
U
Fig.31
W
A
For MX-K30
W
A
For MX-K10
REC/PB Head
V
U
Fig.32
Fig.33
Advertisement
