Table of Contents
Advertisement
Sending Faxes
Difficulty
Cannot send a fax.
Transmission Verification Report
says 'Result:NG'.
Poor fax send quality.
Vertical black lines when sending.
Handling Incoming Calls
Difficulty
The machine 'Hears' a voice as a
CNG Tone.
Sending a fax call to the machine.
Custom features on a single line.
Suggestions
Check all line cord connections. Make sure the telephone line cord is plugged into
the telephone wall jack and the LINE jack of the machine.
Make sure that the Fax
on page 40.)
Ask the other party to check that the receiving machine has paper.
Print the Transmission Verification Report and check for an error. (See Reports
on page 91.)
There is probably temporary noise or static on the line. Try sending the fax again.
If you send a PC FAX message and get
Verification Report, your machine may be out of memory. To gain extra memory,
you can turn off Memory Receive (see Turning off Memory Receive Operations
on page 60), print fax messages in memory (see Printing a fax from the memory
on page 55) or cancel a Delayed Fax or Polling Job (see Canceling a fax in
progress on page 42). If the problem continues, ask the telephone company to
check your telephone line.
If you often get transmission errors due to possible interference on the telephone
line, try changing the menu setting of Compatibility to Basic(for VoIP). (See
Telephone line interference on page 155.)
Try changing your resolution to Fine or S.Fine. Make a copy to check your
machine's scanner operation. If the copy quality is not good, clean the scanner.
(See Cleaning the scanner on page 171.)
Black vertical lines on faxes you send are typically caused by dirt or correction fluid
on the glass strip. Clean the glass strip. (See Cleaning the scanner on page 171.)
Suggestions
If Easy Receive is set to On, your machine is more sensitive to sounds. It may
mistakenly interpret certain voices or music on the line as a fax machine calling
and respond with fax receiving tones. Deactivate the machine by pressing
Stop/Exit. Try avoiding this problem by turning Easy Receive off. (See Easy
Receive on page 53.)
If you answered on an extension telephone, press your Fax Receive Code (the
factory setting is l 5 1). If you answer on an external telephone (connected to the
EXT jack), press Start to receive the fax. When your machine answers, hang up.
If you have Call Waiting, Call Waiting/Caller ID, Voice Mail, an alarm system or
other custom feature on a single telephone line with your machine, it may create
a problem sending or receiving faxes.
For example: If you subscribe to Call Waiting or some other custom service and
its signal comes through the line while your machine is sending or receiving a fax,
the signal can temporarily interrupt or disrupt the faxes. Brother's ECM (Error
Correction Mode) feature should help overcome this problem. This condition is
related to the telephone system industry and is common to all devices that send
and receive information on a single, shared line with custom features. If avoiding
a slight interruption is crucial to your business, a separate telephone line with no
custom features is recommended.
Troubleshooting and Routine Maintenance
key is illuminated. (See Entering Fax mode
'
'
Result:NG
on the Transmission
B
151
Advertisement
Table of Contents
