Gsm Hb Transmit Calibration Failure - Huawei Mediapad S7-PRO Maintenance Manual

9.12.6 GSM HB Transmit Calibration Failure

2012-07-20
S7-PRO Maintenance Manual (Basic Version V2.1)
Power on the
board
Check whether the
19.2 MHz crystal
(X1) is normal
Y
Yes
Check whether the
power supply for
QTR8615 (U23)
Yes
Check whether QTR8615
can output the signal
TX_GSM_LB normally
Yes
Check whether the
TX_DCS1800_PCS19 power
output of the power amplifier (U47)
is within the specified range
Yes
Check whether the antenna switch
(U46) works normally
Yes
End
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Maintenance procedures
No
Replace X1
No
Check the input power of QTR8615
No
Replace QTR8615 (U23)
Y
Check the input signal, output signal, and
No
power supply. If any exception is found,
replace the power amplifier (U47)
Check the input signal, output signal,
logic control signal, and power
No
supply. If any exception is found,
INTERNAL
replace U46
Page 74 of 97