Configuring The Programming Station Software For Use With A Usb Network Dongle - HEIDENHAIN TNC 320 Operating Instructions Manual

Configuring the programming station software
for use with a USB network dongle
All computers to which you want to give access to a network dongle
must be configured in the following way:
 Start the programming station software
 Double-click the green HEIDENHAIN symbol to the lower right in
the taskbar for the TNC Control Panel to appear (see figure)
 Click the More >> button: Additional settings are displayed

Click the Settings button: Programming station settings are
displayed
 Select the Use Hardlock Server option
 In the Server input field, enter the IP address or the network name
of the computer which you are using as a server, i.e. the computer
to which you have connected the USB network dongle

Press OK to confirm your settings
Changes do not take effect until you restart the
programming station software: Press the Restart TNC
button.
You do not need to install any additional drivers on the
client PC to be able to access the USB network dongle.
HEIDENHAIN Programming Station TNC 320/TNC 620/TNC 640 55