Power Interposer Board; Removing The Power Interposer Board; Installing The Power Interposer Board - Dell EMC PowerEdge R750xs Installation And Service Manual

Power interposer board

This is a service technician replaceable part only.

Removing the power interposer board

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
4. Remove the PSU.
5. Disconnect the cables that are connected to power interposer board (PIB).
Steps
1. Using a Phillips #2 screwdriver, remove the screws securing the power interposer board (PIB) to the system.
NOTE: Observe the routing of the cable as you remove it from the system.
2. Lift the PIB away from the system.
Figure 124. Removing the power interposer board
Next steps
Replace the power interposer

Installing the power interposer board

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
124 Installing and removing system components
Safety instructions.
Before working inside your
board.
Safety instructions.
Before working inside your
system.
system.