Royal Alba THERMO Manual page 26

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 20
6
INSTALLATION
PLACE OF INSTALLATION
6.1
In the product manual are indicated the minimum
expressed in cm that must be respected when positioning
the cooker (Fig. 6.1)
be in a non-combustible, non-heat sensitive material. To
the contrary use appropriate protection in insulating and
non-combustible material.
If the floor is made of inflammable material before
positioning the cooker we suggest laying a 2-3 mm thick
metal plate that juts out by at least 80 cm from the front
of the cooker (Fig. 6.1).
The cooker should also be kept at a minimum safety
distance of approximately 30 cm from the surrounding
walls.
Any claddings in combustible material above the cooker
(for example beams and wooden ceilings) must be
screened by diaphragms in non-combustible insulating
material.
Provide a space of at least 10 cm on the left side of
the kitchen to allow proper ventilation.
The cooker not suitable for recessed.
Provide a technical space accessible for any
maintenance.
6.2
COMBUSTION AIR
While it is operating, the cooker uses a modest quantity
of air taken from the room in which is it installed: this air
must be replaced by means of an air intake outside the
room itself (Fig. 6.2; A external air intake).
The EXTERNAL AIR INTAKE is indispensable to ensure
COMBUSTION AIR, especially if doors
and windows are double-glazed and sealed.
If the wall behind the cooker is an outside wall, make a
20-30 cm.
If several cookers are installed in the same place, it is
advisable to increase the cross-section of the external
air intake for each cooker to avoid low air pressure and
consequent formation of smoke.
The hole must be protected, on the outside with a
permanent ventilation grille suitable to prevent insects
and small animals from entering. In particularly windy
areas that are exposed to bad weather it is advisable to
install a rain and wind guard.
If the wall behind the cooker is not an outside one, it is
possible to make a hole connecting to the outside on an
adjacent wall as long as it communicates permanently
with the rooms in which the cookers are installed by
means of a transit grille.
The UNI 10683 standard forbids taking air for
26
INSTALLAZIONE
INSTALLAZIONE
Fig. 5.3
Fig. 6.1
A
Fig. 6.2
must not
y
x
Z
Y1
X1
30
80
30
00 477 7250 -09/2018 - PN - Italy
X2
Y2

Advertisement

Table of Contents
loading

Table of Contents