Nokia 8208 Service Manual page 98

Setup for TX Troubleshooting
Use the following steps to configure FTM for RF troubleshooting.
1. Connect RF test connector to a CMU200.
2. Connect the mobile terminal to PC via the Module Jig, and connect a power supply.
3. Open RF Toolkit in L3 program. The RF Toolkit appears.
4. Click "Start RF connection" in connection.
5. Select "FTM" in phone mode setting
6. Select band mode "Cellular band/PCS band" in
click "Set band" .
7. Set a channel "384/600" in
Cellular Band Test channel
PCS Band Test channel
8. Select "On" in TX on/off
9. Select "Off" in waveform
10. Select "0 - R0_On R1_On" in
11. Set "110" in AGC and click "set AGC".
12. After finish above checking, select "Online" in " phone mode setting" and
click "Set phone mode".
Page 4-10
and click "set mode" .
band setting
RF channel setting and click "Set channel" .
: 384
: 600
and click "set Tx On/off" .
and click "Set waveform".
PA Range and lick "Set PA Range".
Figure 39 Steps of configuring FTM for RF troubleshooting
Company Confidential
Copyright © 2008 Nokia. All rights reserved.
and
RM-384
RF Troubleshooting
Issue1