Enclosure Preparation; Electrical Preparation - Blomberg DWT37300 Installation Manual

6. ENCLOSURE PREPARATION

Notice :
 For proper dishwasher operation and appearance ensure that the enclosure has the
minimum dimensions shown in the figure above.

6.1 ELECTRICAL PREPARATION

WARNING
To avoid electrical shock and/or a fire hazard, make sure electrical work is properly
installed. Only qualified electricians should perform electrical work.
Before installation disconnect the power supply to the work area by unplugging the
unit, "tripping" the circuit breaker or removing the fuse.
The installer has the responsibility of ensuring that the dishwasher electrical
installation is in compliance with all national and local electrical codes and ordinances.
The dishwasher is designed for an electrical supply of 120 V, 60 Hz, AC, connected
to a dishwasher-dedicated, properly grounded electrical circuit with a fuse or breaker
rated for 15 amperes.
” )
3 0
(
WARNING
Electrical supply cords must be a minimum #14AWG
copper wire.
Position the cable extending approximately 30" (760mm)
from the enclosure's back (Figure A).
Position the cable extending at the bottom
(Figure B).
Remove 2
cable's outer casing, and then remove
(9-13mm) of insulation from each wire. (Figure C)
6
USA
15 / 15 /
" - 3 " (75mm-100mm) of the
16 16
3 / 1 /
" - "
8 2