Adjustments - Blodgett SB-10G Installation Operation & Maintenance

7. Rinse entire unit and dry. DO NOT GET WATER in electrical box or any electrical
component.

7.0 ADJUSTMENTS

At least twice a year have an authorized service person clean and adjust the unit for
maximum performance.
BOILER DESCALING INSTRUCTIONS
It is recommended that the boiler should be checked every 90 to 120 days for scale build
up. Regular maintenance should be carried out at this time.
If the boiler has been descaled, a new Anode should be installed in the boiler to help
extend its life.
1. With boiler empty, close manual blowdown valve. If appliance is equipped with
automatic blowdown, turn water supply OFF to appliance. Turn power switch ON.
This will energize and close blowdown valve.
2. Remove 3/4" pipe plug from fitting on left front of boiler.
3. Insert appropriate hose or tube through fitting and pour in (½) half gallon (U.S.) of
CLR Descaling Solution or use the Optional Deliming Assembly DPA-1 available
from your dealer.
For appliances equipped with CSD-1, descaling solution must be introduced
through hand hole.
4. Replace 3/4" pipe plug securely.
5. Open water supply to appliance allowing water to fill boiler to required level.
6. Let appliance cycle, allow two hours for descaling and cleaning. DO NOT TURN
STEAM ON TO THE COMPARTMENTS.
7. Open both the blowdown and low water level control valves for complete drainage
and then close both valves.
Appliance equipped with automatic blowdown - turn OFF power switch and open
low water control valve. This will allow complete drainage. Once drained close
water level control valve.
8. Turn appliance switch ON. When boiler is completely filled, turn power switch OFF.
This will rinse and drain boiler. Appliance with manual blowdown valve must be
opened to drain.
9. Complete Step 8 twice to assure boiler is completely rinsed.
19