Kodak Instamatic M Series Repairing page 47

the shutter—the tab on the cap aligns with the lamp box.
Before you replace the lamp housing, make sure the exten-
sion on the cap points straight down as shown in Fig. MD15.
LAMP-HOUSING SCREWS
FIG. MD13 Underside of projector mechanism.
SHUTTER
SHUTTER CAP
FIG. MD15 Bottom of projector, viewed from the back—lamp housing removed.
Compliments of:
www.KodakParts.com
LAMP HOUSING
LAMP HOUSING
FIG. MD14 Bottom of projector mechanism
from back.
IN-AND-OUT CAM
CAM-SHAFT GEAR
45/KODAK M-SERIES PROJECTORS
DISCONNECT HOOKED END OF SPRING
REMOVE SCREW