Korg SDD-3000 PEDAL Owner's Manual page 23

Setting functions
For the operating procedure, refer to "Setting procedure".
Setting the bypass sound
When you want to turn off (bypass) an effect, select the bypass sound.
Tip: The bypass sound is set to analog bypass as the factory default.
: Analog bypass. Use this to output only the sounds that bypass through the analog circuit,
but not through DSP, A/D or D/A.A.
: True bypass.
Seamless bypass
When bypass is set, you can switch the bypass sound while the reverberant sound remains.
Tip: Seamless bypass is enabled as the factory default.
: Enable.
: Disable.
When the bypass sound is set to true bypass, seamless bypass is disabled.
Seamless Program Change
When switching programs, you can switch the following programs while the reverberant sound
remains.
Tip: Seamless Program Change is enabled as the factory default.
: Enable.
: Disable.
Constant Parameters
This function leaves the parameters before they are changed when the delay type is changed by
the SELECT button in the DELAY TIME section.
Tip: The Constant Parameters feature is disabled as the factory default.
: Enable.
: Disable.
23