Blaupunkt Miami Beach CD148 Owner's Records page 7

DON'T connect two speakers to a single pair of speaker leads ("in parallel") unless both speakers
l
each have at least 8 ohms impedance.
DON'T connect the left and right speaker leads to each other or to the same speakers.
l
DON'T connect the front and rear speaker leads to each other or to the same speakers.
l
DON'T connect the negative speaker leads to each other.
l
DON'T connect the positive speaker leads to each other.
l
DON'T connect any active speakers (with built-in amplifiers) to the speaker leads unless their
l
owner's manuals specifically state that this is O.K.
Cover the ends of any unused leads with electrical tape. This will prevent them from touching the
l
vehicle or each other and causing a short-circuit and damage to the receiver or vehicle.
Connecting the Pre-Amp Outputs to External Amplifier(s)
To prevent short circuits or serious damage to the receiver, amplifier, and/or speakers:
Follow the amplifier's instructions on how to connect the unit's preamp outputs to the amplifier(s)
l
and connect the speaker(s) directly to the amplifier.
INPUT JACK
ANTENNA MOTOR
TRIGGER SWITCH
LEFT REAR
SPEAKER
ARY
B L A C K _
RI
SPEAKER
RIGHT REAR
SPEAKER
SPEAKERS
RED
BLACK _ G R O U N D
Harness has single blue lead that car
l
be used for either antenna motor c
amp trigger or spliced for use wit I
both. (See note 3.)
7