Adjusting The Gain For An Auxiliary Device; Speaker Zones; Dsp Settings - Garmin RV 890 Owner's Manual

Adjusting the Gain for an Auxiliary Device

You can adjust the gain for a connected auxiliary device to achieve a volume level similar to that of other media
sources. You can adjust the gain in 1 dB increments.
1 Select an auxiliary source.
2 Move the slider to increase or decrease the gain.
NOTE: To achieve the best audio quality when using a portable media player with a headphone output, it
may be necessary to adjust the volume control on the media player, instead of adjusting the gain.

Speaker Zones

You can group speakers in one area into a speaker zone. This enables you to control the audio level of the
zones individually. For example, you could make the audio quieter in the cabin and louder on deck.
You can set the balance, volume limit, tone, subwoofer level, subwoofer frequency, and name for each zone,
and configure other zone-specific settings
Adjusting the Audio Settings for a Zone
1 Select > Tools > Fusion Link >
2 Select a zone.
3 Select More.
4 Select one or more options:
NOTE: Not all options are available for all zones.
• To limit the maximum volume level of this zone, select VOLUME LIMIT, and adjust the level.
• To set the subwoofer level for this zone, select SUB LEVEL, and adjust the level.
• To adjust the right and left speaker balance of this zone, select BALANCE, and adjust the balance.
Adjusting the Subwoofer Filter
You can use the subwoofer filter setting to control the subwoofer cutoff frequency for each zone, which can
enhance the blend of the sound produced by the speakers and the subwoofer. Audio signals above the selected
cutoff frequency are not passed to the subwoofer.
NOTE: If a DSP setting has been applied to the zone, this setting cannot be changed on the stereo. You can
view the DSP setting for the optimal cutoff frequency as calculated by the DSP controller, but you cannot adjust
it.
1 Select > Tools > Fusion Link >
2 Select a zone.
3 Select Subwoofer Filter.
4 Select a frequency.

DSP Settings

Some Fusion stereos feature digital signal processing (DSP). You can select pre-configured DSP settings for
Fusion speakers and amplifiers to optimize audio quality.
All DSP settings are configured using the Fusion-Link remote control app.
NOTE: This feature is not available for all stereo models.
40
(Speaker Zone Settings, page
> Music.
> Music.
41).
Using the Apps