Write-Protecting Tape Cartridges; Figure 3.3 Ultrium Tape Cartridge And Proper Barcode Label Placement; Figure 3.4 Write-Protecting The Ultrium Data Cartridge - Fujitsu ETERNUS LT40 S2 Installing, Starting Up And Maintaining

Chapter 3 Operating the Tape Library
3.3 Tape Cartridges

Figure 3.3 Ultrium tape cartridge and proper barcode label placement

CAUTION
3.3.4

Write-protecting Tape Cartridges

All rewritable data cartridges have a write-protect switch to prevent accidental erasure or overwriting of data.
Before loading a cartridge into the library, make sure the write-protect switch on the front of the cartridge is
in the desired position.
• Slide the switch to the right to write-protect the cartridge. A small pad-lock is visible indicating that the
cartridge is write-protected (see
• Slide the switch to the left to allow the library to write data to the cartridge (see

Figure 3.4 Write-protecting the Ultrium data cartridge

FUJITSU Storage ETERNUS LT40 S2/LT60 S2 LTO Library Installing, Starting Up and Maintaining
The barcode label should only be applied as shown in
alphanumeric portion facing the hub side of the tape cartridge. Never apply
multiple labels onto a cartridge, as extra labels can cause the cartridge to jam in
a tape drive.
Figure 3.4).
46
Copyright 2018 FUJITSU LIMITED
Figure 3.3 with the
Figure 3.4).
P3AM-5392-07ENZ0