12 o’clock position. controls. They let you voice the TubeMeister 18’s Then adjust GAIN/MASTER settings at will to get two channels. To set the basic volume level for a taste of the very different flavors of preamp and power tube distortion.
Page 3
NOTE: Be advised that you cannot mute the Its dynamic range is considerable, sweeping from TubeMeister 18 by turning the LEAD MASTER knob pristine clean to throaty crunch sounds. Remarkably all the way down (to the far left position). If you wish...
TIP: This port gives you another hip remote-control the front panel button. You can then switch BOOST option: If you wish to control the TubeMeister 18 via footswitch only, and the button merely serves to via MIDI, connect a MIDI switcher or looper to this indicate the function’s status.
tightly focused response, set the POWER SOAK to SPEAKER jack if you wish. To do so, simply unplug full power and turn the MASTER knob down. If the built-in speaker. you want classic rock sounds replete with spongier MAINS IN power tube saturation, drop the POWER SOAK down to a lower setting and crank the MASTER Connect the factory-included power cord (MAINS...
Tube Safety Control (TSC) One LED flashes constantly. TSC adjusts bias to improve the amp’s tonal and technical stability and extend power tubes’ life. It The tube assigned to this flashing LED is generating does this automatically and continuously, so there is over-voltage.
Technical Specifications TubeMeister 18 Head & Combo Preamp tubes: 2 x 12AX7 / ECC83 Power tubes: 2 x EL84 Power output: 18 watts Max. power consumption: 101 watts Mains voltage tolerance range: +/-10% Ambient operating temperature range: 0° to +35° C Mains fuse, 100 volts: 250 V / T 1.25 A L...