Indesit IWDE12 Operating Instructions

Download this manual

Operating Instructions – Washer dryer Indesit IWDE12

Control Panel

Starting a wash cycle

1. Switch the washer-dryer on by pressing

Lock Led will begin to flash.

2. Load your laundry into the washer-dryer and shut the appliance door.

3. Set the Programme knob to the programme required.

4. Set the wash temperature

5. Set the drying cycle if necessary

6. Add the detergent and any fabric softener

7. Start the programme by pressing the Start/Reset button. To cancel it, keep the Start/Reset button pressed for at

least 2 seconds.

8. When the programme is finished, the On-Off/Door Lock LED will flash to indicate that the appliance door can be

opened. Take out your laundry and leave the appliance door ajar to allow the drum to dry thoroughly. Turn the

washer-dryer off by pressing button

. All the LEDs will light up for a few seconds and the On-Off/Door

Page 1 Operating Instructions – Washer dryer Indesit IWDE12 Control Panel Starting a wash cycle 1. Switch the washer-dryer on by pressing . All the LEDs will light up for a few seconds and the On-Off/Door Lock Led will begin to flash.
Page 2 Programme table Setting the temperature Turn the temperature knob to set the wash temperature. The temperature can be lowered, or even set to a cold wash Set the drying cycle Turn the drying knob to select the desired drying option. There are two options: A- Based on time: From 40 minutes to 150.
Page 3 A cooling stage is foreseen at the end of the drying cycle. If your laundry load to wash and dry is in excess of the maximum load (see table below), perform the wash cycle and when the programme is complete, divide up the garments and put part of them back in the drum. Now follow the instructions provided for a dry only cycle.