Sony Handycam DCR-DVD910 Operating Manual page 21

b Notes
• Disconnect the AC Adaptor from the DC IN
jack holding both the camcorder and the DC
plug.
To remove the battery pack
1 Turn the POWER switch to OFF
(CHG).
2 Press and hold the BATT (battery)
release button and remove the battery
pack in the direction of the arrow.
BATT (battery) release button
b Notes
• When you remove the battery pack or the AC
Adaptor, make sure that the
(Still) lamp (p. 23)/ACCESS lamp (p. 27)/
access lamp (p. 29) are turned off.
• When you store the battery pack, fully discharge
the battery before storing it for an extended
period (p. 115).
To use a power source from a wall
outlet (wall socket)
Make the same connections as you do when
charging the battery pack. The battery pack
will not lose its charge in this case.
To check the remaining battery
(Battery Info)
Set the POWER switch to OFF (CHG), then
press DISP/BATT INFO.
After a while, the approximate recordable
time and battery information appear for
about 7 seconds. You can view the battery
information for up to 20 seconds by
pressing DISP/BATT INFO again while the
information is displayed.
(Movie) lamp/
Charging time
Approximate time (min.) required when
you fully charge a fully discharged battery
pack.
Battery pack
NP-FH50
NP-FH60
(supplied)
NP-FH70
NP-FH100
Remaining battery (approx.)
Recording capacity (approx.)
Charging time
135
135
170
390
21
Continued ,