Lenovo ThinkSystem SR250 Messages And Codes Reference page 48

Automatically notify Support: No
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0185
User Action:
Information only; no action is required.
• FQXSPFW2002I: The System [ComputerSystemElementName] has recovered from a firmware
hang.
This message is for the use case when an implementation has recovered from a System Firmware Hang.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0187
User Action:
Information only; no action is required.
• FQXSPIO0000I: The connector [PhysicalConnectorElementName] has been connected.
This message is for the use case when an implementation has detected a Connector has been
Connected.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Warning - Other
SNMP Trap ID: 60
CIM Prefix: PLAT CIM ID: 0264
User Action:
Information only; no action is required
• FQXSPIO0001L: The connector [PhysicalConnectorElementName] has encountered a
configuration error.
This message is for the use case when an implementation has detected an Interconnect Configuration
Error.
Severity: Error
Serviceable: Yes
Automatically notify Support: Yes
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0266
User Action:
Complete the following steps until the problem is solved:
1. Make sure USB cable from front I/O module to system board is securely connected.
2. Replace the front operator panel if the problem still exist.
• FQXSPIO0003N: A diagnostic interrupt has occurred on system [ComputerSystemElementName].
44
ThinkSystem SR250 Messages and Codes Reference