Establishing A Telnet Session Through The Management Module - IBM Brocade 4 Gb SAN Switch Module Installation Manual

Establishing a Telnet session through the management
module
To establish a Telnet session through the blade management module, complete the following steps:
Note: The sample screens that appear in this document might differ slightly from the screens that
are displayed by your system. Screen content varies according to the firmware versions and options
that are installed.
1. In the address bar of your browser type http://xxx.xxx.xxx.xxx, where xxx.xxx.xxx.xxx is the IP
address of the blade management module interface. Click GO or press Enter. The Enter Network
Password window opens.
Note: The default IP address for the blade management module is 192.168.70.125.
2. In the User Name field, type the initial default user name, USERID. In the Password field, type
the initial default password, PASSW0RD (the sixth character is a zero, not the letter O). The user
name and password are case sensitive.
The management-module Welcome window opens.
3. In the Inactive session timeout value field, select the timeout value for this Web session and
click Continue.
The management-module main window opens.
4. In the left navigation pane, under I/O Module Tasks, click Management.
The I/O Module Management window opens.
5. Click the link for either Bay 3 or Bay 4.
The Management window opens.
6. Make sure that the IP address is the same in the Current IP Configuration and New Static IP
Configuration sections.
7. Click Advanced Management. The Switch Management window opens.
8. To start a Telnet session, scroll down to the Start Telnet/Web Session section and click Start
Telnet Session.
The management-module command-prompt window opens.
9. At the Login prompt, type the initial default user name, USERID, and press Enter. At the
Password prompt, type the initial default password, PASSW0RD (the sixth character is a zero,
not the letter O), and press Enter. The user name and password are case sensitive.
10. If you are accessing the switch module for the first time, press Enter to change the switch
passwords. You are prompted for a password for the root, factory, and user accounts.
To open online help to view the available commands, type help and press Enter.
For more information about using the CLI, see the Brocade Fabric OS Command Reference Manual
on the Resource CD.
20
Brocade 4 Gb SAN Switch Module: Installation Guide