Siemens Stratos Outstation Installation Manual page 24

Maintenance
7 Plug the Ethernet cable (supplied separately) into the Ethernet port on the Router and
into the Laptops Ethernet port.
8 Set up the communications on the router (see below)
The settings for each router will change between sites and customer systems.
Before trying to set up a router, you should have received all configuration information, or a
configuration file for the router, or both. This would normally be provided by the Poole Engi-
neering Department.
Safety of Profile
The UTC instation should be configured to use a communications profile that is compatible
with the physical network layer (ADSL, wireless, 3G etc). This should be checked with the in-
station operator.
A.2 Inhand 3G Router Commissioning
Instation should use the 3G communications profile.
This type of 3G router would normally be set up using a Private APN, this would be requested
by the customer and the information supplied.
You would normally expect to be provided with the following information:
•
Mobile APN and Password
•
Local (LAN) IP address for the Router (Also the Gateway for other devices on the LAN)
•
LAN Subnet Mask/ Netmask
•
LAN IP address for the Outstation Device (e.g. UTMC OTU)
• LAN IP address for the Engineers Laptop
•
Port Forwarding details (NAT)
•
VPN (IPSEC) settings (usually instead of NAT above)
IP ROUTERS INSTALLATION GUIDE 3G OTU
667/CI/45025/000 Rev 4 Unrestricted
24