Wiring - Honeywell PRO4200 Installation Manual

Installing the PRO4200 Two Reader Module

Wiring

(1,200 m) total per port. Use twisted pair (minimum 24 AWG) with shield for
communication. The default speed of this port is 38.4Kbps but it can be downgraded
to 19.2Kbps or 9.6Kbps if the line conditions or receiving equipment require it (see
Table 1 on page 3 for jumper settings and Table 2 on page 4 for DIP switch settings).
For wiring to an RS-485 port:
1. TR+ is the plus side of the transmit and receive differential signal.
2. TR- is the negative side of the transmit and receive differential signal.
3. GND is the signal ground.The wiring for this signal is required and NOT optional.
This signal must NOT be connected to chassis GND.
4. Use 24 AWG low capacitance, twisted-pair, shielded cable (Honeywell 3328 or
equivalent).
Wiring
This section presents information on reader wiring, input wiring, and control output
wiring.
The following figure shows the PRO4200 board and identifies its terminal block pin
assignments.
PRO4200 Two-reader module User Guide, Document 800-25698V1 17