Set Supervisor / User Password - Biostar M7VKE User Manual

Chapter2

2.12 Set Supervisor / User Password

Figure 12. Set Supervisor / User Password
CMOS Setup Utility-Copyright (C ) 1984-2000 Award Software
► Standard CMOS Features
► Advanced BIOS Features
► Advanced Chipset Features
► Integrated Peripherals
► Power Management Setup
► PnP/PCI Configurations
► PC Health Status
Esc : Quit F9 : Menu in BIOS
F10 : Save & Exit Setup
When you select this function, the following message will appear at the center of
the screen to assist you in creating a password.
Type the password, up to eight characters, and press <Enter>. The password you
type now will clear any previously entered password from CMOS memory. You
will be asked to confirm the password. Type the password again and press
<Enter>. You may also press <ESC> to abort the selection and not enter a
password. To disable password, just press <Enter> when you are prompted to
enter password. A message will confirm that you wish to disable the password.
Once the password is disabled, the system will boot and you can enter setup
freely.
► Frequency/Voltage Control
Load Fail-Safe Defaults
Load Optimized Defaults
Set Supervisor Password
Set User Password
Enter Password:
Save & Exit Setup
Exit Without Saving
Change/Set/Disable password
ENTER PASSWORD
2-34
BIOS Setup
: Select Item